Caterpillar robot uses squishy, 3-D printed legs to inch and crawl | Science News

MISSION CRITICAL

Support credible science journalism.

Subscribe to Science News today.



Science Ticker

Your daily roundup of research news

Science News Staff
Science Ticker

Caterpillar robot uses squishy, 3-D printed legs to inch and crawl

caterpillar robot

SQUISHY PARTS  Soft legs help this robot sense the environment and switch between two different caterpillar-like gaits.

Sponsor Message

View video

A robot caterpillar can use squishy legs to sense the world.

Roboticist Takuya Umedachi and colleagues designed the robot after studying real-life caterpillars. These insects can “bend, wrinkle, buckle, twist, droop, and creep” their way through the environment, and they do it “without massively complex brains,” the researchers write December 7 in Royal Society Open Science.

To mimic a caterpillar, Umedachi’s team built a version that included motors, pulleys and wire. It’s 23 centimeters long — about the length of a tissue box — with four contracting segments, and those squishy legs. Sensors detect when the legs bend. That’s a cue for the robot to crawl, one segment contracting after another in a wave.

But when Umedachi covered the middle two legs with tape, they no longer had enough purchase to push off the ground — they didn’t bend. “It’s slippery, like walking on ice,” says Umedachi, of the University of Tokyo. That’s enough info for the robot to change its gait — without using a lot of “brain” power. When those middle legs stay straight, the robot switches to a new caterpillar-like movement: like an inchworm, back leg scooching to front, and then front leg stretching forward.

A pliable body lets robots sense and interact with the environment, Umedachi says. And it could give machines yet another way to become more aware of themselves — and their surroundings.

SOFT WALKER When this caterpillar robot’s soft legs press against the floor, they bend — a signal to crawl (top). Tape covering the middle legs (green) makes them slip, not bend, so the bot inches along instead (bottom). T. Umedachi et al./Royal Society Open Science 2016

Get Science News headlines by e-mail.

More Math & Technology articles