New insulation material is practically weightless yet still durable | Science News

Real Science. Real News.

Science News is a nonprofit.

Support us by subscribing now.


A new insulation material is practically weightless yet still durable

The porous aerogel is at least 99 percent air

2:00pm, February 14, 2019

DAINTY INSULATOR  A new insulator that’s at least 99 percent open space can withstand extreme heat that would obliterate other substances.

Sponsor Message

A new, nearly weightless insulation material can withstand extreme heat that would destroy other materials.

The porous aerogel is at least 99 percent open space, with the rest made up of an atomically thin ceramic called hexagonal boron nitride. The design proves extremely durable under high temperatures and rapid temperature shifts of over 1,000 degrees Celsius, researchers report in the Feb. 15 Science.

“It’s notoriously hard to make materials that are not just lightweight, but can also be heavily heat resistant,” says Deep Jariwala, an engineer at the University of Pennsylvania who coauthored a commentary on the study in the same issue of Science. The new ultralight insulator may be especially well suited to shielding components on spacecraft, which must endure extreme temperature swings when turning toward or away from the sun or re-entering Earth’s atmosphere, he says.

Bring the heat

Researchers placed a fresh flower atop a 2-centimeter-thick piece of a new insulator and lit a flame underneath (as seen in the photo on the left and the heat map on the right). After 15 minutes, the top surface of the aerogel was a mere 45° C, and the flower was only slightly withered.

The aerogel comprises a network of tiny air pockets, with each pocket separated by two atomically thin layers of hexagonal boron nitride. Much like how double-pane windows prevent heat from escaping a house in winter, the double-pane ceramic barrier makes it difficult for heat to transfer from one air bubble to another. It’s also difficult for heat to spread through the material by traveling along the hexagonal boron nitride layers themselves, because that would require following long, circuitous routes, explains study coauthor Xiangfeng Duan, a chemist and materials scientist at the University of California, Los Angeles.

Whereas other ceramic aerogels are liable to break down under sudden temperature shifts or extended heat exposure, the new aerogel withstood 500 cycles of rapid heating and cooling from –198° C to 900° C, as well as sitting at a scalding 1400° C for one week. A piece of the insulator also successfully shielded a flower held over a roughly 500° C flame.

Because the material’s structure is so sparse, it's probably not usable on its own, says Julia Greer, a materials scientist at Caltech not involved in the work. The aerogel is resilient in the sense that it’s soft and squishable. But to protect the aerogel from tears, it would likely have to be packaged inside a sturdier material, she says.


X. Xu et al. Double-negative-index ceramic aerogels for thermal superinsulation. Science. Vol. 363. February 15, 2019, p. 723. doi:10.1126/science.aav7304.

M. Chhowalla and D. Jariwala. Hyperbolic 3D architectures with 2D ceramics. Science. Vol. 363. February 15, 2019, p. 694. doi:10.1126/science.aaw5670.

Further Reading

L. Grossman. How the Parker probe was built to survive close encounters with the sun. Science News. Vol. 194, September 15, 2018, p. 16.

M. Temming. New technique shows how 2-D thin films take the heat. Science News Online, February 13, 2018.

Get Science News headlines by e-mail.

More on Favorite books of 2016

From the Nature Index Paid Content